Troubleshooting - Electrolux Refine 600 E6SI3-61 Series Instruction Book

Denim
Please follow the instructions of your garment care label.
Varied ironing speed and fabric dampness might cause optimal setting to differ from the
recommendations in the table!

TROUBLESHOOTING

PROBLEM
Soleplate is not heating even
though iron is turned on.
Iron does not produce steam.
Steam jet and vertical steam jet
function does not work.
Water leaks from the soleplate
during ironing.
Water leaks from the soleplate
while the iron is cooling down or
after it has been stored.
Flakes and impurities come out
of the soleplate during ironing.
Brown streaks come out of the
soleplate while ironing and stain
the linen.
www.electrolux.com
Cotton or Linen
POSSIBLE CAUSE
Connection problem
Temperature control is in
"Delicate" position.
Not enough water in tank.
Selected temperature is lower
than that specified to use with
steam.
Steam jet function was used very
frequently within a short period.
Iron is not hot enough.
Iron is not hot enough.
You may have forgot to put
steam lever in "no steam
position".
You may have used hard water,
which has caused scale flakes to
develop in the water tank.
You may have used non
recommended chemical
descaling agents.
Fabric fibers have accumulated
in the holes of the soleplate and
are burning.
Fabrics might not be properly
rinsed or the garments are new
and have not been washed
before ironing.
Use maximum steam. Apply maximum steam by
pressing and holding the steam on/off button.
SOLUTION
Select higher programme like
"Cotton".
Select higher programme like
"Cotton".
Fill water tank (see "Getting
started", no 2).
Increase temperature to at least
"Cotton".
Put iron on horizontal position
and wait before using steam jet
function.
Select the Cotton setting
("Cotton" to "Linen") suitable for
steam ironing. Put the iron on its
heel and wait until temperature
indicator light turns off.
Select the Cotton setting
("Cotton" to "Linen") suitable for
steam ironing. Put the iron on its
heel and wait until temperature
indicator light turns off.
Turn steam lever to "no steam
position" position when finished
ironing (see "After use", no 12).
Clean the iron according
to Cleaning section (see
"Maintenence", no 16).
Clean the iron according
to Cleaning section (see
"Maintenence", no 16).
Clean the soleplate with a damp
soft cloth.
Please rinse the fabrics properly
before ironing.
EN
CNS
KR
ID
TH
VN
5