Troubleshooting - Electrolux RENEW 800 Instruction Book

EN
FABRIC
CNS
Denim
CNT
Please follow the instructions of your garment care label.
Varied ironing speed and fabric dampness might cause optimal setting to differ from the
recommendations in the table!
KR
There might be some water drops when the steam boost button is pulled at or
ID

TROUBLESHOOTING

TH
PROBLEM
VN
Soleplate is not heating
even though iron is turned
on.
Iron does not produce
steam.
Steam boost and vertical
steam boost function does
not work.
Water leaks from the
soleplate during ironing.
Flakes and impurities come
out of the soleplate during
ironing.
Water leaks from the
soleplate while the iron is
cooling down or after it has
been stored.
Brown streaks come out of
the soleplate while ironing
and stain the linen.
8
TEMPERATURE
IRONING RECOMMENDATION
SETTING
Cotton or Use maximum steam. Apply maximum steam by pressing
Linen
and holding the steam boost button.
POSSIBLE CAUSE
Connection problem
Temperature setting is lower than
"OUTDOOR" position.
Not enough water in tank.
Selected temperature is lower
than that specified to use with
steam.
Steam boost function was used
very frequently within a short
period.
Iron is not hot enough.
The iron is not hot enough.
You have used hard water,
which has caused scale flakes to
develop in the water tank. Clean
the station with descaler (see
"Cleaning", no 14).
The iron has been put in
horizontal position while there is
still water in the water tank.
You may have used chemical
descaling agents different from
the recommendation.
Fabric fibers have accumulated
in the holes of the soleplate and
are burning.
Fabrics might not be properly
rinsed or the garments are new
and have not been washed
before ironing.
.
SOLUTION
Check main power supply cable, plug
and outlet.
Select adequate temperature like
"Cotton".
Fill water tank (see "Getting started",
no 2).
Increase temperature to at least
"Cotton".
Put iron on horizontal position and
wait before using steam boost
function.
Adjust the proper temperature to
steam ironing (up to "Cotton"). Put
iron in vertical position and wait until
temperature indicator light turns off.
Set the temperature dial to a
temperature ("Cotton" to maximum)
suitable for steam ironing. Put the iron
on its heel and wait until the headlight
is on before you start ironing.
Press and hold the steam button for
about one minute to get steam. Then
hold one more minute in order to clean
the steam generating system. Before
starting ironing, please test your iron
on an old towel to ensure that no
residues inside the iron are transferred
to your garments.
Empty the water tank and switch off
the steam station by pressing ON/OFF
button (M) on the boiler unit before
storing the iron.
Use the descaling agent from the
recommendation (see "Cleaning", no
14).
Clean the soleplate with a damp soft
cloth.
Please rinse the fabrics properly
before ironing.
www.electrolux.com