Digigram ALP221e User Manual page 23

User Manual – ALP221e
can be adjusted via the faders.
There are three ways of adjusting the digital gain.
1) Click and hold the fader button down and move the mouse vertically
2) Press the Ctrl key without releasing and then click on the fader
3) Click on the gain value displayed below the fader, write and enter the
Double click on the fader to reset the digital gain to 0 dB.
Digital gain values range from -90 dB to +12 dB, in steps of 0.1 dB.
The Vu-meters display the levels in peak-meter.
The clipping threshold of the vu-meters can be adjusted from the global
menu "Settings/Audio meters" . When the signal level exceeds this
threshold, the red LED above the Vu-meter lights up.
48V phantom power (only on ALP222e-Mic)
Setting the phantom power on each analog input of the ALP222e-Mic is
possible when the input is set to Mic level mode.
Solo
The solo button has an effect on the two channels of a stereo pair.
A click on this button sets the two channels in solo mode, and it turns
yellow.
Mute
The mute button has an effect on the two channels of a stereo pair.
A click on this button sets the two channels in mute mode, and it turns
red.
Pairing channel strips
To set a common level for several input channel strips, validate the button
on each channel strip. The gain setting on one channel strip is then
applied to all the paired channel strips.
to increase/decrease the gain in 0.1 dB steps.
button. The gain can be adjusted with the mouse wheel in 1 dB steps
as long as the Ctrl key remains pressed.
new value.
23