Table of Contents
Advertisement
Installation (continued)
Installing the brackets to the projector
After installing the projector mount bracket (sold separately) to the projector, install the angle adjusting bracket
by following the procedure below.
Angle adjusting bracket
Projector mount
bracket
Suspending the projector
Angle adjusting bracket
Angle adjusting bracket
Temporarily secure
in 2 places
10 - ENGLISH
A
Temporarily
secure in 4
places.
B
A
Hooks
Angle adjusting bracket
Angle adjusting bracket
As shown in the figure on the left, temporarily se-
cure the angle adjusting bracket
mount bracket with the 4 supplied captive washer
hex head bolts.
Note
z The illustrations for the projector and the pro-
jector mount bracket may be different from real
products.
1 Fit the hook of angle adjusting bracket
captive washer hex head bolts which are tempo-
rarily tightened in step 1 on page 8.
Attention
z Do not remove your hands from the projector
until the captive washer hex head bolts of angle
adjusting bracket
L-shaped grooves.
WARNING
■ Mounting and installation must be
carried out by two or more persons.
2 Temporarily secure angle adjusting brackets
and
B
with the 2 supplied captive w-asher hex
head bolts as shown in the illustration on the left.
B
Attention
A
z Make sure that the projector is horizontal when
temporarily tightening the fixing captive washer
hex head bolts.
A
to the projector
A
on the
B
are firmly hooked into the
A
A
Advertisement
Table of Contents
