Table of Contents
Advertisement
Adjusting the installation angle
z It is possible to adjust the horizontal swing and also the horizontal and vertical tilt of the ceiling mount bracket.
z For the projector with the lens shift function, check that the projector lens is in the standard position*
just the positioning of the projected image and the screen.
z While referring to the operating instructions for the projector, project a picture onto the screen and then adjust
the picture size and focus. After making these adjustments, adjust the ceiling mount bracket angle.
*
1
For the projector with the lens shift function, standard position is a state when the lens position is in the center
(lens center).
■ If the picture is too far to the left or right of the screen
■ If the picture is too far to the top or bottom of the screen
Hex head bolts securing angle
adjusting brackets
and
A
(two each at left and right)
5° above horizontal
20° below horizontal
To the screen
■ If the picture is tilted to the left or right
±10 °
Note
z If there is still vertical keystone distortion after adjusting the angle of the ceiling mount bracket and Keystone in
the Position on screen menu has not been adjusted, the screen and projector are not correctly aligned. Check
the standard installation dimensions while referring to "Standard installation dimensions" on the installation
instruction of the projector mount bracket. Or adjust keystone on the projector.
Attention
z After checking the position adjustments, check that the screws have been tightened to the torques specified on page 6.
Hex head bolts, captive washer (×3)
Adjustment pole A
,
rotation range ±5°
B
Captive washer hex head
bolts securing projector
mount bracket and angle
adjusting bracket
A
1 Loosen the captive washer hex head bolts (x3) that
temporarily secure the adjustment pole
tachment plate, then turn the pole to align the image
center to the screen center.
2 Once the picture is positioned correctly, securely
tighten the captive washer hex head bolts (x3).
Attention
z Do not loosen the captive washer hex head bolts that
temporarily secure the adjustment pole
tachment plate too much. Otherwise the projector may
fall down.
z For the projector with the lens shift function, it can also
be adjusted by using the lens shift function.
1 Loosen the captive washer hex head bolts (two each
at left and right) that temporarily secure angle adjust-
ing brackets
A
and
the projector up or down to align the picture position
with the screen position.
2 Once the picture is positioned correctly, securely
tighten the captive washer hex head bolts (two each
at left and right).
Attention
z Do not loosen the captive washer hex head bolts that
temporarily secure the angle adjusting brackets
too much. Otherwise the projector may fall down.
B
1 Loosen the captive washer hex head bolts (two at
each end) that temporarily secure the projector mount
bracket and angle adjusting bracket
projector and correct tilt.
2 Once the picture is positioned correctly, securely
tighten the captive washer hex head bolts (two at
each end).
Attention
z Do not loosen the captive washer hex head bolts that
temporarily secure the projector mount bracket and
angle adjusting bracket
projector may fall down.
, and ad-
1
A
to the at-
A
to the at-
, and then move the front of
B
A
to turn the
A
too much. Otherwise the
ENGLISH - 11
A
and
Advertisement
Table of Contents
