Table of Contents
Advertisement
Installation (continued)
Adjustment pole preparation
Install adjustment pole
below.
Adjustment pole
Provisionally tighten the
bolts at the left and right.
Angle adjusting
bracket
Arrow
Adjustment pole
8 - ENGLISH
to adjustment pole
B
A
inscription
FRONT
Fully tighten the captive
washer hex head bolts
at the front and back.
Provisionally tighten the
captive washer hex
head bolt (x 6)
Adjustment pole
and to angle adjusting bracket
1 Use the 4 supplied captive washer hex head bolts
to secure the angle adjusting bracket
adjustment pole
the left.
Attention
z Temporarily tighten the captive washer hex head
bolts at left and right.
z Align the
pole
B
bracket
2 Insert the adjustment pole
pole
A
so that the holes are aligned, and then
use the 6 supplied captive washer hex head bolts
to temporarily secure them.
Attention
z The adjustment poles
vided with holes which are spaced at 20-mm
intervals.
Temporarily secure the poles together so that the
hole positions match the height obtained from
the standard installation dimensions which are
described in the installation instructions of the
projector mount bracket.
z Align the
pole
A
adjustment pole
3 Securely tighten the 2 captive washer hex head
bolts at the front which were temporarily tightened
in step 2.
4 Securely tighten the remaining 4 captive washer
hex head bolts at the rear which were temporarily
tightened in step 2.
Attention
z Be sure to secure the adjustment poles
B
at all six points.
by following the procedure
B
B
as shown in the illustration on
inscription on the adjustment
FRONT
with the arrow on the angle adjusting
B
.
into the adjustment
B
A
and
B
inscription on the adjustment
FRONT
with the
inscription on the
FRONT
.
B
B
to the
are both pro-
A
and
Advertisement
Table of Contents
