Mounting Procedure; Main Procedures; Changing The Orientation Of The Main Unit Of The Projector - Panasonic ET-JPF200BE Operating Instructions Manual

Mounting procedure

Main procedures

The main procedures up until installation of the projector are as follows.
For details on 1) to 3), refer to the corresponding reference pages.
1) Changing the orientation of the main unit of the projector ( page 7)
2) Mounting the floor stand to the projector ( page 8)
3) Connecting the power cord to the projector ( page 10)
4) Installation
z Install the projector while referring to "Projection dimensions" in the operating instructions for the projector.
Then adjust the orientation of the main unit as described in "Adjusting the projection position".
z If necessary, refer to "Attaching a security wire" ( page 12) in this manual and take a measure to
protect the equipment against theft.

Changing the orientation of the main unit of the projector

This section describes changing the orientation of the main unit of the projector to make the mounting work easier
to do.
Ball joint fixing screw
Ball joint stopper
Shaft holder
1) Place the projector on a cloth or the like that
has been laid on a flat surface.
2) Loosen the ball joint fixing screw.
z Loosen the ball joint fixing screw of the
3) Change the orientation of the main unit.
z Loosening the ball joint fixing screw enables
Main unit
4) Tighten the ball joint fixing screw.
z Tighten the ball joint fixing screw with the allen
Attention
z When loosening the ball joint fixing screw with the
pole being held by hand, take care to avoid the
hand(s) or fingers being pinched between the pole
and the main unit.
projector with the allen wrench (5.0 mm (3/16ʺ)
across flats) supplied with the projector.
rotation of the shaft holder so that the
orientation of the main unit can be changed.
wrench (5.0 mm (3/16ʺ) across flats) supplied
with the projector to prevent the main unit
moving during the mounting work.
ENGLISH - 7