Page 1
* The figure above shows a combination of this product and the separately sold ceiling mount bracket (for low ceilings) ET-PKL100S. Thank you for purchasing this Panasonic Product. To customers The “Installation Instructions” is intended for use by installation personnel. Be sure to employ certified personnel to perform the installation.
Electric shocks may result from contact with any metal objects inside the ceiling. r Panasonic takes no responsibility for any accident or damage caused by the installation of the ceiling mount bracket using methods that are not described or methods that do not use the parts specified in these Installation Instructions.
Product description This is a projector mount bracket for installing projectors. ■ Applicable ceiling mount brackets ET-PKL100S (for low ceilings) / ET-PKL100H (for high ceilings) Note z In this document, the alphabet letters at the end of the projector part numbers are omitted. ■...
Installation position The dimensional relationship between the screen and projector is shown below. Establish the ceiling installation position after accessing the dimensional relationship diagram and the Dimension- al relationship. The projection distance can be adjusted using the zoom lens. Check the projection screen while making fine ad- justments.
Page 6
Installation position (continued) Note z This illustration assumes that the projector will be installed so that the projected image fills the screen and properly aligned with it. z This drawing is not in exact scale. Height of the projection Distance from the center of lens to the image upper end area Width of the projection Distance from the center of lens to the attachment plate (including...
Installation After checking the height, width and structure of the installation location while referring to the “Dimensional relationship diagram” (pages 5-6) and “Dimensional relationship” in the Appendix, determine the appropriate posi- tions for setting up the screen and installing the projector. Setting up the screen Set up the screen according to the specified method in a position which takes into account the projection distance and angle and the type of screen being used.
Installation (continued) <For PT-VW355N, PT-VW350, PT-VX425N, PT-VX420, PT-VX421; PT-VW360, PT-VX430, PT-VX431K> Wire rope Screw, captive Note washer z For the position of A of the PT-VW355N, PT-VW350, PT-VX425N, PT-VX420, PT-VX421; PT-VW360, PT-VX430, PT-VX431K models, refer to the image on the left. Screw, captive Wire washer...
Page 9
Installation (continued) <For PT-VW355N, PT-VW350, PT-VX425N, PT-VX420, PT-VX421; PT-VW360, PT-VX430, PT-VX431K> 1 Secure the projector mount bracket to the bottom of Captive washer Wire rope the projector using three supplied captive washer screws (M4 × 10) screws (M4 × 10) as illustrated on the left. z Use three of the four captive washer screws sup- plied with this product.