Data Memory; Viewing The Stored Values; Clearing All Values; Battery Indicator And Battery Change - Microlife BP W3 Comfort Instructions Manual

Hide thumbs Also See for BP W3 Comfort:
Table of Contents

Advertisement

Available languages

Available languages

6. Data memory

This device automatically stores the last 30 measurement values.

Viewing the stored values

Press the M-button 3 briefly, when the device is switched off. The
display first shows «M» AK, and «A»which stands for the average of
all stored values.
Pressing the M-button again displays the previous value. Pressing
the M-button repeatedly enables you to move from one stored value
to another.
Blood pressure readings with suboptimal cuff fit AO-A are not
considered in the average value.

Clearing all values

If you are sure that you want to permanently remove all stored
values, hold down the M-button (the device must have been
switched off beforehand) until «CL» appears and then release the
button. To permanently clear the memory, press the M-button while
«CL» is flashing. Individual values cannot be cleared.
Cancel deletion: press ON/OFF button 1 while «CL ALL»
is flashing.
Microlife BP W3 Comfort

7. Battery indicator and battery change

Low battery

When the batteries are approximately ¾ empty the battery symbol
AQ will flash as soon as the device is switched on (partly filled battery
displayed). Although the device will continue to measure reliably,
you should obtain replacement batteries.

Flat battery - replacement

When the batteries are flat, the battery symbol AQ will flash as soon
as the device is switched on (flat battery displayed). You cannot take
any further measurements and must replace the batteries.
1. Open the battery compartment 5 by pulling off the cap.
2. Replace the batteries – ensure correct polarity as shown by the
symbols in the compartment.
3. To set date and time, follow the procedure described in Section
«2. Using the device for the first time».
The memory retains all values although date and time must
be reset – the year number therefore flashes automatically
after the batteries are replaced.

Which batteries and which procedure?

Use 2 new, long-life 1.5 V, size AAA alkaline batteries.
7
EN

Advertisement

Table of Contents
loading

Table of Contents