Advertisement
Available languages
Available languages
Problem
Little or no material flow
Material leaking
Atomization is too coarse
Pattern runs or sags
Too much overspray
Pattern is very light
and splotchy
Spluttering paint
Inlet hose not sucking up water when
cleaning the unit
Paint station is automatically stopping
and starting
Fluid is leaking out of the housing hole
Wear ear-muffs.
The impact of noise can cause damage to hearing.
The specified vibration value was established in
accordance with a standardized testing method. It may
change according to how the electric equipment is used
and may exceed the specified value in exceprional
circumstances.
The specified vibration value can be used to compare the
equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
TROUBLE SHOOTING
Cause
Nozzle clogged
Suction tube clogged
Pressure control dial turned too
low (-)
Suction tube loose
Inlet filter clogged
Nozzle loose
Nozzle worn
Nozzle seal worn
Material build-up on air cap and
nozzle
Larger tip and filter required
Material volume too large
Nozzle clogged
Inlet filter clogged
Applying too much material
Gun too far from spray object
Too much material applied
Moving the spray gun too fast
Air bubbles in the return pipe
Lack of pressure
This is normal. This ensures the
correct operating pressure is
maintained
The O-Rings may be worn and
need replacing.
Keep the noise emissions and vibrations to a minimum.
• Only use appliances which are in perfect working order.
• Service and clean the appliance regularly.
• Adapt your working style to suit the appliance.
• Do not overload the appliance.
• Have the appliance serviced whenever necessary.
• Switch the appliance off when it is not in use.
• Wear protective gloves.
28
EN | ENGLISH
Remedy
Clean using needle
Clean
Increase pressure control dial setting
(+)
Insert and tighten hose clamp
Clean or replace
Tighten
Replace
Replace
Clean
Refer to spray tip selection chart
Decrease pressure control dial setting
(-)
Clean
Clean or replace
Adjust pressure control dial or increase
movement of spray gun
Reduce distance
Decrease pressure control dial setting
(-)
Adjust pressure control dial or
decrease movement of spray gun
Complete bleeding operation to remove
air bubbles
Complete the bleeding operation
to re-prime the unit
No issue
Replace the worn O-Rings. Contact
customer service for information on
how to service this part
Advertisement
