Advertisement
Available languages
Available languages
the spray position.
7.
Wait for the Airless Sprayer to automatically cut
out, after a few moments. The sprayer is now ready
to use.
Note: The airless sprayer automatically shuts off once
the operating pressure is reached and will start-up again
when it drops below the cut-in pressure.
PRESSURE RELEASE PROCEDURE
WARNING!
BEFORE
BEGINNING
PROCESS, ENSURE THE
PRESSURE
RELEASE
PERFORMED.
Follow this procedure diligently as a build-up of dried
paint on the operating components can stop the unit from
working.
Pressure Release Procedure
1.
Rotate the priming lever into the prime position.
2.
Aim the spray gun into the paint bucket and
squeeze the trigger to release any remaining
pressure in the gun.
THE
CLEANING
PROCEDURE
BELOW
3.
Lock the spray gun trigger.
IS
4.
Switch the spray system off.
If coating material was water based (acrylic paint), use
ONLY water when performing the cleaning
procedure. Use of solvent based cleaning materials on
water based paints will result in a new
substance that will be extremely difficult to clean.
If coating material was oil based (enamel paint etc.) use
ONLY the appropriate cleaning solution.
Read the cleaning instructions printed on the coating
material's label to determine which cleaning
material you need. The following solvent based cleaning
products are safe to use in the airless
paint sprayer:
• Mineral Turpentine
• Paint Thinner
24
EN | ENGLISH
WATER VS OIL BASED
Advertisement
