Advertisement
Available languages
Available languages
1.
Secure inlet hose by tightening the screw on hose
clamp with butterfly head clockwise.
Spray Tip & Guard
Note: The spray gun comes assembled from the factory.
If the spray gun has
been disassembled for cleaning, follow the steps below
to re-assemble.
1.
Push the mesh filter into the spray head and then
insert the handle over the mesh filter.
2.
Ensure the trigger guard is attached to the handle
and tighten the handle using a 19mm spanner.
3.
Insert the nozzle tip all the way into the nozzle.
4.
Attach and tighten the nozzle to the spray gun
using a 27mm spanner.
PAINTING PREPARATION
WARNING! THIS TOOL IS RECOMMENDED FOR THE USE
WITH RESIDUAL
CURRENT DEVICE WITH A RATED RESIDUAL CURRENT
OF 30MA OR LESS.
Note: You do not need to thin paint for use in this spray
gun.
Locking the Spray Gun Trigger
The spray gun trigger should be locked prior to preparing
the spray station to
ensure the trigger does not accidentally get released.
1.
To lock the spray gun trigger, rotate the trigger
locking lever clockwise.
2.
To unlock the trigger, rotate the trigger locking
lever anti-clockwise.
22
EN | ENGLISH
Advertisement
