Pro-Craft PSE1100 Manual page 23

Priming Operation
1. Fully submerge filter and return pipe in coating
material.
2. Set priming lever to the prime position.
Note: When changing between different paint colours
you may need to sperate
the return tube into a waste bucket to avoid the small
amount of paint in the
system discolouring the new paint.
3. Adjust the pressure dial to maximum position by
rotating clockwise.
4. Turn the unit on and hold the trigger down to relieve
pressure.
5. Wait for air bubbles to clear the return pipe, this is
indicated by a steady stream of paint out of return
pipe.
6. Release the trigger and switch the priming lever to
23
EN | ENGLISH