Ford SUPER DUTY 2023 Owner's Manual page 516

Changing a Road Wheel
6. Use the ignition key to open the lock at
the rear bumper.
7. One or more handle extensions are
used to operate the spare tire carrier.
To assemble, align the button with the
hole and slide the parts together. To
disconnect, press the button and pull
apart.
E308882
8. The lug wrench is used to turn the
handle extensions and the jack handle;
slide the square end of the handle
extension into the square hold of the
lug wrench until it clicks in place.
E162796
9. Fully insert the jack handle, with one
extension, through the bumper hole
and into the guide tube. Additional
extensions will be needed if the tailgate
is in the lowered position and cannot
be raised. Turn the handle
counterclockwise and lower the spare
2023 Super Duty (TFH) Canada/United States of America, enUSA, Edition date: 202211, DOM
(If Equipped)
tire until you can slide the tire rearward
and the cable is slack. You will feel
some resistance when you turn the jack
handle assembly. If not replacing the
spare or flat tire to the underbody
storage area, raise the wheel retainer
up into the installed position. Do not
store spare or flat tire at other
locations.
10. Slide the retainer through the center
of the spare tire wheel and remove
the spare tire.
E310417
11. Remove the wheel trim with the lug
wrench tip, or use the wheel trim tool
described later in this section.
12. Loosen each wheel nut one-half turn
counterclockwise, but do not remove
them until the wheel is raised off the
ground. For dual rear wheel, assemble
the lug wrench and extension tool
together to access the wheel nuts.
512