Cruise Control; What Is Cruise Control; Switching Cruise Control On And Off; Setting The Cruise Control Speed - Ford SUPER DUTY 2023 Owner's Manual

WHAT IS CRUISE CONTROL

Cruise control lets you maintain a set
speed without keeping your foot on the
accelerator pedal.
Requirements
Use cruise control when the vehicle speed
is greater than 20 km/h in metric units or
15 mph in imperial units.
SWITCHING CRUISE CONTROL
ON AND OFF
WARNING: Do not use cruise
control on winding roads, in heavy traffic
or when the road surface is slippery. This
could result in loss of vehicle control,
serious injury or death.
The cruise controls are on the steering
wheel.
Switching Cruise Control On
Press the button to activate the
system. When the system
E332905
activates, the set speed is equal
to the current vehicle speed or 20 km/h (15
mph), whichever is greater. If the speed is
too low, or other conditions are not correct
for cruise control activation, the system
enters standby mode.
Switching Cruise Control Off
Press the button when the
system is active or switch the
E332905
ignition off.
Note: When you switch cruise control off,
the set speed clears.
2023 Super Duty (TFH) Canada/United States of America, enUSA, Edition date: 202211, DOM

Cruise Control

SETTING THE CRUISE
CONTROL SPEED
downhill, your vehicle speed could
increase above the set speed. The
system does not apply the brakes.
Drive to the speed you prefer.
E246884
E246885
Take your foot off the accelerator pedal.
Note: The indicator changes color in the
information display.
Changing the Set Speed
E246884
SET+ button to accelerate. Release the
button when you have reached your
preferred speed.
E246885
SET- button to decelerate. Release the
button when you have reached your
preferred speed.
Note: If you accelerate by pressing the
accelerator pedal, the set speed does not
change. When you release the accelerator
pedal, your vehicle returns to the speed that
you previously set.
294
WARNING: When you are going
Press either the SET+ or SET-
buttons to set the current speed.
Press the SET+ button to
increase the set speed in small
increments. Press and hold the
Press the SET- button to
decrease the set speed in small
increments. Press and hold the