Table of Contents
Advertisement
41
The same as water sw.
●
6.7 Defrost heater
6.7.1 Basic parameters
Rated voltage: AC115V
Rated power: 240W
1.
Enter Forced defrost mode
, use a multimeter to measure the voltage between pin
●
No.2 and No.7 on CN2 connector of the mainboard, if the voltage doesn't equal to
electric supply power, it means the heater is broken, change it.
2.Use a multimeter to measure resistance of the heater, if the value isn't 55.1Ω±10%,it
is broken, change the heater.
6.8 Removing the Display Component
1. Use Philips screwdriver to remove three fixed screws, as picture 1.
2. Unplug the connecting terminal, as picture 2.
3. Disassemble the fixed screws, as picture 3.
4. Remove the terminal, as picture 4.
5. Remove the two fixed screws, as picture 5.
6. Take out the display component, as picture 6.
Hisense Refrigerator
Advertisement
Table of Contents
