Hisense BCD-560WPZ/HC1 (H) Service Manual page 36

36
as the drawing below.
2. Pin No. 8 connect 12V power and pin No. 9 connect GND, if the freezer fan motor
works normally, change the main-board; If not change the freezer fan motor.
Pin No. 11 connect 12V power and pin No. 12 connect GND, if the condenser fan motor
works normally, change the main-board; If not change the condenser fan motor.
Pin No. 14 connect 12V power and pin No. 15 connect GND, if the convertible fan motor
works normally, change the main-board; If not , change the convertible fan motor.
6.4.3 Removing the fan motor
6.4.3.1 Removing the fridge fan motor
Step 1: Remove the three screws (1) holding the fridge air duct with a Philips screwdriver.
Step 2: Remove the two wire connector (2) by pressing the top of them.
Step 3: Tidy the wire harness (3) after you remove the fridge air duct.
Step 4: Remove the cover (4) with a Philips screwdriver and your both hands.
Step 5: Remove the three screws (5) holding the fan motor with a Philips screwdriver.
Hisense Refrigerator