Agri-Fab 45-03291 Owner's Manual page 7

17. Assemble the vinyl grip (T) onto the flow control arm.
See figure 8.
18. Insert the flow control arm down through the slot in the
flow control bracket. Assemble the small hole of the flow
control link (U) to the flow control arm using a 1/4" x 1"
hex bolt (D), a nylon washer (I) and a 1/4" nylock hex
nut (F) as shown in figure 8. Tighten carefully. The
flow control link should be snug but should pivot with
no more than slight resistance.
(U) FLOW
CONTROL
LINK
(small hole)
(F) 1/4" NYLOCK
HEX NUT
(I) NYLON
WASHER
(D) 1/4" x 1"
HEX BOLT
FIGURE 8
19. Assemble the flow control arm to the flow control
mounting bracket using a 1/4" x 1" hex bolt (D), two
nylon washers (I) and a 1/4" nylock hex nut (F). Tighten
carefully. The flow control arm should be snug but
should pivot with no more than slight resistance. See
figure 9.
(F) 1/4" NYLOCK
HEX NUT
(I) NYLON
WASHERS (2)
FIGURE 9
ENGLISH
(T) VINYL GRIP
(D) 1/4" x 1"
HEX BOLT
20. Hook the double bent end of the flow control rod through
the hole in the slide gate bracket located near the bottom
of the hopper. See figure 10.
FIGURE 10
21. Place a 5/16" flat washer (J) onto the other end of the
flow control rod. Insert the end of the rod through the
curved slot in the flow control mounting bracket and
through the hole in the flow control link. Secure with a
5/16" flat washer (J) and a 3/32" x 3/4" cotter pin (L).
See figure 11.
NOTE: You can leave off the second washer if there is not
enough room on the end of the rod.
FIGURE 11
7
(J) 5/16" FLAT
WASHER
FLOw
CONTROL
ROD
(L) 3/32" HAIR
COTTER PIN
(J) 5/16" FLAT
WASHER