Table of Contents
Advertisement
QUADMO747-E6xx
User Manual - Rev. First Edition: 1.0 - Last Edition: 1.2- Author: S.B. - Reviewed by G.M.
4.4 Chipset Configuration
After the selection of this submenu, it will appear the following table:
The selections above shown are an example and they can be different from the default values.
4.4.1 Video boot Device
This option allows you to choose which the default video output at system boot is. Possible choices
are:
PCI-e;
IGD (Internal Graphics Device)
Using this option is possible to set primary video output, if internal graphics card must be used or if
primary video output must be directed to external video cards (placed on PCI-express bus).
In case IGD is selected, please refer to "Internal Video Boot on" menu item (see paragraph 4.4.3).
4.4.2 Internal Video Memory Mb
This option allows to choose the memory window size reserved for internal graphic controller
(possible choices are OFF, 1 MB, 4MB, 8MB, 16MB, 32MB, 48MB or 64MB). If there is installed in
the system an additional graphic board, it is necessary to set this value to OFF.
4.4.3 Internal Video Boot on
When Video Boot Device is set to IGD, this option allows to select which Quadmo747-E6xx board's
video output must be enabled.
Possible choices are:
SDVO
LVDS
SDVO + LVDS
Note: Quadmo747-E6xx board, like all standard Qseven
interfaces: LVDS and SDVO. SDVO signals are usually converted, on the carrier board, into LVDS,
TV, DVI or CRT format. Please check your carrier board's user manual to determine if you are
going to use direct LVDS interface or (converted) SDVO interface.
Copyright © 2012 SECO s.r.l.
QUADMO747-E6xx
®
boards, has only two graphical
Page 25
Advertisement
Table of Contents
