Advanced Cmos Configuration; Display Tests Behaviour; Show Graphic Logo; Ignore Ide 80 Cable Check - Seco Qseven QUADMO747-E6 Series User Manual

QUADMO747-E6xx
Page 23
User Manual - Rev. First Edition: 1.0 - Last Edition: 1.2- Author: S.B. - Reviewed by G.M.

4.3 Advanced CMOS Configuration

After the selection of this choice, it will appear the following table:
The selections above mentioned are just as an example, they can be different from default values.
Most fields allow two selections:
Disabled / Enabled
i.e., there is only the chance of enable or disable corresponding operations during the system boot.

4.3.1 Display tests behaviour

When "Disabled", it eliminates the message visualisation during initial test.

4.3.2 Show Graphic Logo

This option allows you to enable the visualisation of the graphic logo (a bitmap image 640x480
pixel in 16 colours) during the first steps of boot-up sequence. This image can be customised.

4.3.3 Ignore IDE 80 cable check

When this option is enabled, the system will not perform check of 80-poles cable for IDE Ultra-ATA
133 performances.

4.3.4 NumLock State at Boot

This option allows you to define the NUMLOCK state at Boot, delineating working mode of numeric
keypad.

4.3.5 Wait for F1 on error

When "Enabled", in case of error during the boot phase, the system halts with the request to press
F1 to continue.

4.3.6 Ignore keyboard error

When "Enabled", in case of keyboard error during the boot phase, the system proceeds with the
normal boot sequence.
Copyright © 2012 SECO s.r.l.
QUADMO747-E6xx