Usb Keyboard After Boot; Sata Ahci Option Rom; Peripheral Reset Wait; First / Second / Third / Fourth Boot Device - Seco Qseven QUADMO747-E6 Series User Manual

QUADMO747-E6xx
User Manual - Rev. First Edition: 1.0 - Last Edition: 1.2- Author: S.B. - Reviewed by G.M.

4.3.7 USB Keyboard after boot

During the boot, USB keyboard is always enabled. After this phase, the status of USB keyboard
will depend from the settings of this menu item.

4.3.8 SATA AHCI Option ROM

This option allows enabling or disabling AHCI SATA controller (needed both for internal Flash Disk
and/or for external SATA Disk).

4.3.9 Peripheral reset wait

This option is very useful for the use of some peripherals, which requires more time after the start-
up before that they can grant the access. With this option it is possible to specify how much time
must the system wait before to attempt an access to external peripherals, in order to allow their
complete reset (possible choices are 0, 2, 4 or 8 seconds).

4.3.10 First / Second / Third / Fourth boot device

This option allows you to choose in which order the mass storage devices have to be searched for
a valid O.S. for performing the system start-up. Possible choices for each entry are:
NONE;
SATA0;
SATA1;
USB CD-R;
USB disk.
Int. LAN
Regarding SATA ports, please consider that SATA0 means external SATA Disks, while SATA1
can correspond to internal Flash Disk (if available) or second SATA channel, depending on
configuration purchased.
Please also notice that it is not possible to perform the boot from external SATA CD-ROM drives. If
you need to boot from CD-ROM, you need to use an USB CD-R.
NOTE FOR BOOT FROM LAN: if you need to boot from LAN, a special procedure to configure the
system (Quadmo747-E6xx + Carrier board) properly is needed. Please contact SECO to have
detailed information. Please also consider that you have to Disable SATA AHCI Option ROM (see
par.4.3.8) if you want to boot from the Network.

4.3.11 User Option ROM

This option allows enabling or disabling any additional BIOS customised by the user, which allows
additional features that wouldn't otherwise be implemented in Quadmo747-E6xx module.

4.3.12 RAM test execution

This option allows you to disable RAM test execution during boot phase, in order to allow a faster
boot up of the system.

4.3.13 COM1 console redirection

When this option is enabled, all video output is redirected on an eventual serial port COM1 present
on the Carrier Board. To work, this serial port must be set at standard address 3F8, IRQ4.
This video output can be read using programs like HyperTerminal or Putty, by setting the
communication serial port with the following parameters:
115200bps, 8bit, No Parity, 1 bit stop, No Flow Control.
In case the character set is not visualised correctly, it is necessary:
on HyperTerminal, in ASCII setup tab, please deselect "Wrap Lines that exceed terminal width"
-
option;
on Putty, set the "Character set translation on received data" to CP437.
-
Copyright © 2012 SECO s.r.l.
QUADMO747-E6xx
Page 24