Table of Contents
Advertisement
1. 将交流或直流电源盒组件放入
控制盒内。
2.如图所示,将电源线,龙头感应器线
及电磁阀线与相应的接线端相连
接。然后整理好线束并锁紧控制盒
盖。
注：①为交流电源出线口，使用时，
将①的卡扣（薄片状）去除，保证
出线口光滑。
②为龙头感应器出线口。
五 如何安装排水组件
(1) 大陆版
型号: EX27462T-NW-CP等
旋下排水器盘片(17)，在其底面沿
周围涂上一圈密封油灰。把排水本
体(18)由底下插入面盆。
把排水器盘片(17)旋入排水本体
(18) 。从下方用手拧紧锁紧螺母
(19)，去除多余的油灰。
注意： 在锁紧螺母(19)拧紧后，不
可再调整排水本体的位置，否则将
会破坏油灰密封。
8
电源盒组件
Power unit assebly
电磁阀接线端
Solenoid wire connector
Power wire connector
Apply plumbers putty
涂油灰
电源线接线端
龙头感应线接线端
Sensor wire connector
17
19
18
1. Assemble AC or DC power unit
assembly into control box.
2.Cabing and tidying wires such as
power wire assembly,senor wires
assembly and solenoid wire assembly
to right position. Then lock the control
box.
Note: ① is the outlet of AC power supply.
Remove the clip (lamellar) during the
process of use to ensure the smoothing
of outlet.
② is the outlet of faucet sensor.
How to Install the Drain
(1) Mainland Version
SKU: EX27462T-NW-CP,etc
17
Screw off the drain flange (17) from drain.
Apply a ring of plumbers putty around
underside of the drain flange (17). Insert
the drain body (18) into the lavatory from
18
the underside.
Thread the drain flange (17) onto the drain
Body (18). Tighten the locknut (19) by hand
from the underside of the fixture. Remove
any excess putty.
Note:
Do not try to change the position of
the drain after the locknut (19) is tightened,
or you may break the putty seal.
1451063-T01-B
Advertisement
Table of Contents
