Table of Contents
Advertisement
Connect to
Faucet
Note: Not allowed connect AC 220V electrical source to DC wire connector of AC/DC transformer
注： 交流电源盒需另购。
1. 建议交流电源线采用带绝缘和护套层的电线，导
体标称截面积 0.5mm
称截面积 0.3mm
2
连接。
2.
排线完毕后，应检查并确保所有排、接线无误，
再分别连接电源盒AC接线端与排线管内交流接线
端，以及电源盒DC接线端(黑橙线接头)与控制组
件的电源线接插件（从阀盒内引出的电线).最后
打开AC电源，龙头进入6~50秒自动调距阶段，此
过程龙头不会出水。
2.安装直流电池盒组件
Install DC power unit assembly
1. 取出电池盒组件， 旋松螺钉(15),
按电池盒盖(16)上的正负极标示装
入4节5号电池，紧锁电池盒盖(16)
的螺钉(15)后。
注意：电池极性不能装反，新旧电
池不能混用。
3.接线并固定控制盒组件
Cabling and fix the control box
1451063-T01-B
2
；直流连接线采用导体标
的电线。请严格按照上图进行
Connect to
Connect to
electrical Source
electrical Source
接交流电源
接交流电源
AC220V接入直流DC接线端。
Note: AC/DC transformer need to buy separately.
1.Suggested wire: AC connection wire should with insulated
protecting layer or sleeve and the section should be bigger
than 0.5mm
bigger than 0.3mm
to illustrations above.
2. After wire layout finished, check and repair if needed.
Then connect AC connector of AC/DC transformer to
electrical source from the control box, and DC connector
of AC/DC transformer to control assembly. Turn on AC
electrical power, faucet will be in the period of automatic
adjusting sensing distance (about 6~50 seconds). The
faucet will not work during this period.
15
16
Connect to
Faucet
. The section of DC connection wire should be
2
. The connection pattern must according
2
1.
15
16
4
16
7
Advertisement
Table of Contents
