Installation Instructions; Symbol Description - Hans Grohe Metropol 32532 Series Instructions For Use/Assembly Instructions

�
Safety Notes
� Gloves should be worn during installation to prevent crushing and cutting
injuries.
� Children as well as adults with physical, mental and/or sensoric impairments
must not use this product without proper supervision. Persons under the
influence of alcohol or drugs are prohibited from using this product.
� The product may only be used for bathing, hygienic and body cleaning
purposes.
� Do not allow the streams of the shower touch sensitive body parts (such as your
eyes). An adequate distance must be kept between the shower and you.
� The product may not be used as a holding handle. A separate handle must be
installed.
� The hot and cold supplies must be of equal pressures.

Installation Instructions

• Prior to installation, inspect the product for transport damages. After it has been
installed, no transport or surface damage will be honoured.
• The pipes and the fixture must be installed, flushed and tested as per the
applicable standards.
• The plumbing codes applicable in the respective countries must be observed.
• The mesh washer must be insert to protect the shower against incoming dirt by
pipework. Incoming dirt leads to defects or/and can damage parts of the
shower; such caused faults voids all liability and guarantee claims.
Operating pressure:
Technical Data
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
• Safety against backflow
• The product is exclusively designed for drinking water!

Symbol description

Do not use silicone containing acetic acid!
Adjustment (see page 33)
To adjust the hot water limiter. Using a hot water limiter in combination with a
continuous flow water heater is not recommended.
Maintenance (see page 35)
The check valves must be checked regularly according to EN 806-5 in accord-
ance with national or regional regulations (at least once a year).
Hot and cold supplies are reversed (see page 38)
Dimensions (see page 36)
Flow diagram (see page 36)

Hand shower

Bath Spout
Fault
Insufficient water
Mixer stiff
Mixer dripping
Spout temperature does not correspond with
temperature set
Instantaneous heater didn't work
4
English
Special accessories (order as an extra)
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 70°C
65°C
max. 70°C / 4 min
Cause
- Shower filter seal dirty
- Cartridge defective, calcified
- Cartridge defective
- Hot and cold supplies are reversed
- Shower filter seal dirty
- Flow limiter in handshower isn't removed
Assembly (see page 32)
Spare parts (see page 37)
XXX = Colors
000 = Chrome Plated
140 = Brushed Bronze
340 = Brushed Black Chrome
670 = Matt Black
700 = Matt White
990 = Gold Plated
extension 60 mm #93882000 (see page 37)
Cleaning (see page 34)
Operation (see page 33)
Test certificate (see page 37)
Remedy
- Clean filter seal between shower and hose
- Exchange cartridge
- Exchange cartridge
- Install function block turned through 180º
(see page 38)
- Clean filter seal between shower and hose
- Remove flow limiter