Regular Maintenance; Switching Off The Machine - Jura E6 Instructions For Use Manual

3 Daily operation

Regular maintenance

Switching off the
machine
20
T Clean the fine foam frother (see Chapter 5 'Maintenance –
Cleaning the fine foam frother').
T Remove the milk pipe and rinse it thoroughly under running
water.
T Dismantle and rinse the fine foam frother (see Chapter 5
'Maintenance – Dismantling and rinsing the fine foam
frother').
T Rinse the water tank with clean water.
T Wipe the surface of the machine with a clean, soft, damp
cloth (e.g. microfibre cloth).
You will find more information about caring for your E6 in program-
ming mode (page '2/4') under 'Information'.
Carry out the following maintenance actions regularly or as
required:
U
In the interests of hygiene, we recommend changing the milk
pipe and interchangeable milk spout on a regular basis
(approximately every 3 months). Replacements are available
from specialised dealers. Your E6 is equipped with the HP1
milk system.
U
Clean the inside of the water tank, e.g. with a brush. Further
information about the water tank is provided in these instruc-
tions for use (see Chapter 5 'Maintenance – Descaling the
water tank').
U
Traces of milk and coffee may stick to the top and bottom of
the cup grille. If this happens, clean the cup grille.
When the E6 is switched off, the system is automatically rinsed if a
speciality coffee has been prepared.
T Place a receptacle under the fine foam frother and under the
coffee spout.
T Press the On/Off button Q.
E If milk has been prepared, you will be prompted to clean the
milk system ('Clean the milk
switch-off process continues automatically.
'Machine is rinsing'
system'). After 10 seconds the