Table of Contents
Advertisement
8.6
Programming the radio switch
The function of each switching position of the radio switch is configured during the programming
of the radio switch.
Progamming takes place in two sections:
■
Specifying the rocker configuration.
■
Allocate the BT pellet that is to be controlled with the switch position.
Fig. 9:
Selecting the rocker configuration
The rocker configuration takes place directly after the read-in of the radio switch.
Carry out the following points to configure the rocker:
1. Open the "Aperture" page [1].
–
The number of rockers of the radio switch must match the number of the rockers in the
selection list.
–
The function of the rocker is specified in the selection. Not the technical setup.
–
For the example of the installation, the switch-on is to made at the top, or dimmed
higher or switched off at the bottom or dimmed down. This corresponds to the function
of a toggle switch.
For your information:
In the first selection the switch-on and switch-off or dimming up or down is positioned on a
single switching position, e.g. position 1. This made via the "Switchover" (toggle) function.
–
One tap switches on. A second tap switches off.
–
In the first selection up to four devices can be activated with a switch with 2gang rocker.
2. Select the "Two toggle switches" function [2].
–
The "Aperture" function is updated in the device characteristics [3].
Product manual 2CKA001373B5323
Commissioning
│22
Advertisement
Table of Contents
