Bluetooth Connection And Pairing; Playing Music For The First Time; Running In The New Amplifier - Roksan Audio K3 Set Up Manual And Product Manual

Bluetooth Connection and Pairing

Make sure your source device's Bluetooth is enabled and discoverable. Press the
Bluetooth on/ off button on the front panel of the amplifier, or the BT button on the
remote. This will select the Bluetooth source and when your device has found the
amplifier, 'ROKSAN K3' will appear on your device.
When paired or connected the blue LED will stop flashing and remain on. You are now
ready to stream music to the amplifier from the paired device. If your device is aptX
compatible and contains high resolution audio files, then these will be streamed in the
original high quality bit rate through the amplifier.
NOTE: If you wish to revert to a line level or phono input, push the Bluetooth on/
off button and it will disconnect and the LED will turn off. You can then select the
required input as per normal operation. To reconnect to Bluetooth you must
push the Bluetooth on/off button again. You will then have to re-connect the device (at
which point the blue LED will stop flashing and remain on) but pairing is not necessary.
P L A Y I N G M U S I C F O R T H E F I R S T T I M E
When first turning the amplifier on, it is important to follow these simple steps in order
to protect it and your loudspeakers.
1. Reduce the volume of the amplifier to minimum
2. Start playing from your chosen source (CD, DAC, Turntable, etc) and increase the
volume slowly
3. If connected to the K3 Power Amplifier, the LED indicators on the power amplifier
will automatically switch to red and will be activated within a few seconds.
R U N N I N G I N T H E N E W A M P L I F I E R
Any new electrical equipment requires a "running-in" period, warming up the
components to the optimum working temperatures, acquiring the electromagnetic
properties and stability that offers the listeners optimal musical performance. We suggest
that after the initial playing period the amplifiers should be left playing at low volumes for
up to 40 hours. Clear improvements to clarity and speed will be apparent after the first
10-15 hours of playing with the amplifier reaching its optimal performance after 40 hours.
NOTE: When switched off for long durations the procedure described above
may need to be performed again.
12 roksan.com