Operation - Feider Machines FBVES2800-UK User Manual

4.3.3- Collection box (Fig.4)
To insert the collection box:
Press down the lock button (A).
Then insert the collection box into the sliding rails (8).
Press the lock button (A) upward.
To remove the collection box:
Press down the lock button (A).
Then slide the collection box out of the undercarriage.
Note: Before you remove and empty the collection box, ensure
that the machine has been disconnected from its power supply.
4.4- Start and Stop (Fig.5)
To Start the machine:
Press the Forward/Reverse switch (A) to FORWARD
position.
Press the On/Off switch (B) to (I) ON position to start the motor.
To Stop the machine:
Press the On/Off switch (B) to (O) OFF position to stop the motor.
4.5- Overload protection (Fig.5)
This machine is equipped with an overload protection system, to protect the motor from being damaged. The
safety switch will automatically switch off the power when the motor is overloaded.
Wait for at least 1 minute before restarting by first pressing the reset button and then the On/Off switch.
If the motor does not restart, do the following (wear safety gloves) :
1. Press the safety switch (C).
2. Press the Forward/Reverse switch (A) to REVERSE
3. Press and hold the On/Off switch (B) to (I) ON position to remove any objects that could obstruct the blades.

6. OPERATION

5.1- Intended use
- The product is intended for outdoor domestic use in private gardens.
- The product is designed to shred garden debris such as clippings and small twigs within the limits of its
characteristics (smaller than 40mm in diameter).
It is not to be used for any other purpose outside of the described scope in this manual.
- It is recommended to use the product only on dry surfaces, do NOT operate on damp or wet working area.
- Do not use the machine for unsuitable purposes (for ex. for shredding other materials such as plastic, paper;
metal...)
- The tool is not intended for artisanal, commercial, professional or industrial use (ex.: in public parks...).
5.2- Operation
BEFORE any operation:
-- Always visually inspect that the product does not show signs of use or damage. Replace any used or
damaged part.
-- Check that the screws, bolts and nuts are well tightened. Tighten firmly the screws, bolts and nuts when
needed.
-- Ensure that the collection box is properly and securely installed.
-- Ensure that the machine is only connected to conventional sockets with a 230-240V alternating current
supply.
-- Only use extension cables, if they are really necessary, intended for outdoor use and approved.
The use of extension cables may cause a drop in voltage, which will result in the machine not performing to its
peak or the motor overheating.
-- Look into the feeding chamber to make sure it is empty. Do NOT start machine before clearing any material
still present in the feeding chamber.
DURING operation
position.
16
Fig.4
Fig.5