Getting Started - Feider Machines FBVES2800-UK User Manual

5. GETTING STARTED

4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not missing or damaged.
- If you find anything part missing or damaged, do not operate the tool until the part
has been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
4.2- Content
The unit package contains:
- Main unit
- 1 Collection box
- 1 Push stick
- Hex Wrench
- Instructions manual
4.3- Assembly
The machine requires some assembly prior to first time use.
This includes fitting the wheels, the tubes (support feet) to the housing and collection box.
4.3.1- Tubes (Support Feet, see Fig.2)
Turn the shredder upside down and pivot the tubes (support feet) upward.
Insert the supplied wheel axle (A) through the respective openings of each tube.
4.3.2- Wheels (Fig.3)
Put the supplied washer (B) and sleeve (C) onto the wheel axle (A) (Fig. 3B)
Place the wheels (D) and tighten nut (E) by hand (Fig. 3C).
Using the supplied hex wrench (F), fix the wheel axle and at the same time firmly tighten the nut by using a
wrench (not supplied) (G). (Fig. 3D)
Finally, place the wheel cover (H) in the center of the wheel. (Fig. 3E)
Fig.2
Fig.3c
Turn the shredder back on its stand and wheels.
ATTENTION: Take care when turning the unit onto its wheels as the unit has an uneven weight
distribution.
Fig.3a
Fig.3d
15
Fig.3b
Fig.3e