YILMAZ KP 120 Manual page 35

7.2.4 Squeeze the Aluminum profile pressing left pedal to move moveable control unit (PICTURE 2). At the same time
profile centering set square (PICTURE 3 NO.47) will come upwards and moves towards the profile's center.
After a certain amount of distance transfer of moving stops.
7.2.5 After forward movement stops, operator turns the Volant manually (PICTURE 2 NO.65) towards right (in clock
wise) so as to centering set square presses on aluminum profile and provides lateral force coming from knives
pressing.
7.2.6 Move the moveable pressing unit with pressing knives towards the profile pressing the foot pedal (PICTURE 2)
located at the right hand side of (When pressed right pedal the motor operates and hydraulic pistons move
forward PICTURE 2 NO.50). When the pressure is released on the pedal moveable pressing unit returns back.
7.2.7 Approximately after 15 seconds if the foot pedals are not pressed again the hydraulic system motor goes to
stand by position, and remains in that position till foot pedals are pressed again
7.2.8 Loosen the counter nut and increase amount of forward movement step by step until required pressing
dimension is realized on the aluminum profile. (PICTURE 4 NO.49). Adjust the dimensions on the profile
accurately using millimeter scale over the moveable unit.(PICTURE 4 NO.81)
7.2.9 In any danger situation or canceling the operation after it has already started, machine can be
pressing, Emergency Stop button
7.2.10 Switch the system start switch to "0"
NOTE: While pressing is in process pressing force on each unit is 5000 kgs, and movement of the
pressing units is 65mm.
stopped by
35