Operation - YILMAZ KP 120 Manual

NO.1). Knife slots can be used as single or double knife according to the height and specifications of Aluminum
profile.
7.1.3 Control crimping blades against corrosion, distortion and fractions. If crimping blades are damaged, change
them.
7.1.4 Place the Aluminum profile in 90° so that it leans on rear leaner. Use height adjustment screw to adjust rear
leaner height according to Aluminum profile's height PICTURE 5 NO.5 (with the aid of 5 mm Allen key)
7.1.5 Verify that aluminum profiles leans to the rear leaner and that the clamps squeeze the profile
7.1.6 Turn the volant on the chassis (PICTURE 2 NO.65) manually in counter-clockwise so as to take away the profile
centering group (PICTURE 3 NO.47) from the center of the machine to back side.
7.1.7 In case of using an aluminum profile with a narrow dimension approach the rear profile leaner (PICTURE 5
NO.3 ) towards the center of the machine using the scale (PICTURE 5 NO.37) on it.
7.1.8 Do not process the profile before clamping the work piece properly.

7.2 Operation

7.2.1 Switch the system start switch to "1"
7.2.2 Leave the two pieces of prepared aluminum profiles, that are cut to 45 degrees and the intermediate joining
piece is attached, on the table by resting them against the rear stop on the top table.
7.2.3 Touch the eccentric profile leaner on top of the machine to profiles and fix them with the pipo screws on top
(PICTURE 3 NO.51)
well.
34