Advertisement
SETUP, ASSEMBLY AND ADJUSTMENT
The trike comes partially assembled. Adult assembly is required. Trike contains
small parts and are a choking hazard to children under the age of 3 years.
TOOLS REQUIRED:
Phillips Head Screwdriver and an Adjustable Wrench.
WARNING:
in the trike's unassembled state. In the unassembled state, this package contains small parts.
Adult assembly is required; children should not handle parts, or help in assembly of the trike.
1. AXLE AND REAR
DECK ASSEMBLY
• Slide the axle through the rear deck of the
trike.
• Insert one plastic spacer onto the axle then
snap the rear wheel to the axle until it locks
into place.
• Repeat the last step on the other end of the
deck (see figure 1).
2. FRAME AND REAR
AXLE ASSEMBLY
• Insert the rear deck into the slots on back
of the frame.
• Be sure the seat mounts on the frame are
facing upwards.
• Insert both bolts into the corresponding
holes on the top of the deck.
• Attach both nuts under the deck and
tighten them securely with the bolts as
shown (see figure 2).
3. HANDLEBAR AND
FORK ASSEMBLY
• Insert fork into bottom of the head tube on
the frame (note: there is a slot in the fork
stem, making sure it is facing backward).
• Slide a plastic washer followed by a locking
ring over the top of the fork.
• Insert handlebar into the fork.
• Ensure the handlebar is perpendicular to
and properly oriented to the front wheel.
• Ensure the minimum insertion line is below
the locking ring.
• Verify the fork is flush with the head tube of
the frame and tighten the locking ring with
an adjustable wrench (see figure 3).
WARNING:
result in the handlebars falling off and cause risk of injury. Periodically check to ensure the
handlebar is securely attached.
8
Children can be harmed by small parts, sharp edges and sharp points
Failure to properly install the handlebar and secure it to the fork can
D
Figure 1
Figure 2
Figure 3
Advertisement
