Cs-Series Optical Ring Controller Link Units; Overview - Omron SYSMAC CS1W-CLK13 Operation Manual

CS-series Optical Ring Controller Link Units

4-1 CS-series Optical Ring Controller Link Units
4-1-1

Overview

Note
76
Before starting communications, the following settings are required for an
Optical Ring Controller Link Unit (H-PCF cable or GI cable) used with a CS-
series PLC.
Item
Unit number
Node address
Duplex settings (when using Commu-
nications Units in duplex operation)
Transmission path format
For details on duplex settings, refer to 8-3 Procedure for Using Duplex Units.
UNIT UNIT
No. No.
NODE NODE
1 0
No. No.
x10 x10 x10
H-PCF cable GI cable
Unit Number
0 to F (default is 0)
Node Address
01 to 62 (default is 01) (See note.) All nodes in the Network
With the token-bus method, the maximum number of nodes in an Optical Bus
System (i.e., model numbers ending in CLK11) with nodes is 32 (node
addresses 1 to 32).
Duplex Settings for Communications Units (PLC Setup)
Refer to 8-3 Procedure for Using Duplex Units.
Setting location
Unit number switch
Node address switches
PLC Setup
Software switch
1 0
x10
Setting range
Setting range
Section 4-1
Page
77
78
207
79
Unit Number setting
Node Address setting
Nodes
All nodes in the Network
Nodes