Operation; Connecting The Power Cable And Turning On The Projector - NEC GT950 User Manual

3. OPERATION

This section describes how to select a computer or video source, how to adjust the picture, and how to customize the menu or projector settings.

Connecting the Power Cable and Turning on the Projector

Before you turn on your projector, ensure that the computer or video source is turned on and that your lens hood cap is removed.
1. Connect the supplied power cable to the projector.
Plug the supplied power cable in the wall outlet. The projector will go into its standby mode and the power indicator will glow orange.
2. Turn on and off the Projector.
OFF
VIDEO S-VIDEO
AUTO ADJ.
To turn on the projector:
Only after you press the "ON/STAND BY" button on the projector cabinet or "POWER ON" button on the remote control will the power
indicator turn to green and the projector become ready to use.
NOTE: To turn the projector on by plugging in the power cable, use the menu and enable the "Auto Start" feature. (See page E-45.)
NOTE: Immediately after turning on the projector, screen flicker may occur. This is not a fault. Wait 3 to 5 minutes until the lamp lighting is stabilized.
Status of Indicators:
Stand by
STATUS
POWER
Steady orange light
A C
I N
ON
Power "ON/STAND BY" button
POWER
RGB1 RGB2
LASER
SELECT
Lamp Mode:
Normal mode
OFF ON
POWER
Flashing green light
Steady green light
Lamp Mode: Flashing 3 minutes.
During this time Normal mode is
Eco mode
forcefully selected.
D V
I- I
IN P
U T
A U
R G
D IO
B IN
IN P
P U U
T
R G A U
D IO
B O
IN P
U T
P U U
T
P C
L /M
A U
C O O N
D IO
N T O
O U
R O
T P
L
V ID R
E O
A U
D IO
IN P
M O
U S U T
O U
E
T P
U T
S - V
ID E
R E O
M O
C O
T E
N T A U
IN P
R O D IO
U T L
IN P
U T
A U
D IO
O U
T P
U T
Indicators
STATUS
Steady light POWER
Steady green light
STATUS
Steady green light
POWER
E – 27
STATUS
POWER