Auto Adjust; Auto Start; Power Management; Power Off Confirmation - NEC GT950 User Manual

[Page4]

Auto Adjust:

When "Auto Adjust" is set to "On", the projector automatically de-
termines the best resolution for the current RGB input signal to
project an image using NEC's Advanced AccuBlend Intelligent Pixel
Blending Technology.
The image can be automatically adjusted for position and stability;
"Horizontal Position", "Vertical Position", "Clock" and "Phase".
On ................ Automatically adjusts image "Horizontal Position", "Vertical
Position", "Clock" and "Phase".
Off ................ User can adjust the image display functions ("Horizontal Po-
sition", "Vertical Position", "Clock" and "Phase") manually.

Auto Start:

Turns the projector on automatically when the power cable is in-
serted into an active power outlet. This eliminates the need to al-
ways use the "Power" button on the remote control or projector cabi-
net.

Power Management:

When this option is on and there is no RGB input for five minutes or
more, the projector will automatically turn itself off.

Power Off Confirmation:

This option determines whether a confirmation dialog for turning off
the projector will appear or not.
NOTE: When the confirmation message is displayed, you must be in the
Projector mode to operate your projector using the remote control. If not,
press the PJ button on the remote control to change your projector to the
Projector mode. The button lights to indicate that you are in the Projector
mode.

Keystone Save:

This option enables you to save your current keystone settings.
Saving your change once affects all sources. The changes are saved
when you turn off the projector.

Continuous Operation:

This option allows the cooling fans to run at a high speed in the Eco
mode.
When you wish to cool down the temperature inside the projector in
the Eco mode, check this box.
On: ............... Runs the cooling fans at a higher speed than normal opera-
tion.
NOTE: Be sure to select the Eco mode when turning on this option.
Off: .............. Sets the cooling fan speed appropriate for the temperature
inside the projector.

Built-in Speaker:

This option allows you to active the built-in speakers when you con-
nect an audio cable to the AUDIO OUT terminal.

Clear Lamp Hour Meter:

Resets the lamp clock back to zero. Pressing this button appears a
confirmation dialog box. To reset the lamp usage hour, press "OK".
NOTE: The projector will turn off and go into standby mode after 1600 hours
(up to 2100 hours in Eco mode) of service. If this happens, press the "Help"
button on the remote control for ten seconds to reset the lamp clock back
to zero. Do this only after replacing the lamp.

Clear Filter Usage:

Resets the filter usage back to zero. Pressing this button appears a
confirmation dialog box. To reset the filter usage hour, press "OK".
[Page5]

Remote Sensor:

This option determines which remote sensors on the projector are
enabled in wireless mode.
The options are: front, rear, right, or left. All checked boxes indicate
that they can accept the infrared signal from the supplied remote
control.

Control Panel Key Lock:

This option turns on or off the Control Panel Key Lock function.
NOTE:
* This Control Panel Key Lock does not affect the remote control and the
PC Control functions.
* When the cabinet buttons are disabled, pressing and holding the CAN-
CEL button for about 10 seconds will change the setting from "disabled"
to "enabled".

S-Video Mode Select:

This feature is used to select the S-Video signal detection mode.
This allows identifying of the S-Video signals with different aspect
ratio (Zoom signal 16:9, Wide Zoom signal 4:3).
S2 ............... Identifies Zoom or Wide Zoom signal.
OFF ............. Does not identify any S-video signal.
E – 45