Connecting An External Monitor; Connecting A Pc With Dvi Output - NEC GT950 User Manual

Connecting an External Monitor

RGB Signal
cable
To RGB INPUT
(supplied)
You can connect a separate, external monitor to your GT950 projector
to simultaneously view on a monitor the RGB analog, DVI analog, or
component image you're projecting. To do so:
1. Turn off the power to your projector, monitor and computer.
2. Use a 15-pin cable to connect your monitor to the RGB OUT (Mini
D-Sub 15 pin) connector on your projector.
3. Turn on the projector, monitor and the computer.
NOTE:
* The RGB OUT connector outputs RGB signal during standby. When the pro-
jector goes into standby, the image on an external monitor disappears for a
moment.
* The DVI digital output signal from the RGB OUT connector is muted.
* When attaching two D-Sub connector cables to the RGB IN and the RGB
OUT connectors simultaneously, use a cable with connector sizes of 39 mm
x 16 mm (1.53" x 0.63")or less to keep the two connectors from making
contact with each other.
External monitor
O
D I
U
A
D V
I I N
R G
B I
N
D V
I IN
A U
R G
D IO
B IN
IN
R G
A U
B O
R G D IO
B O
IN P
U T
U T U T
P C
L /M
C O O N A U
N T O D IO
R O
O U
L T
V ID R
E O
A U
D IO
M O
IN
U S
O U
E
T P
U T
S - V
ID E
R E O
M O
C O
T E
N T
IN P A U
R O
D IO
U T L
IN

Connecting a PC with DVI output

The DVI input accepts up to the XGA@60Hz signal.
NOTE: The Auto Adjust feature does not work for DVI digital signal. When DVI
signal is selected and the image position is not corrected, adjust the horizontal
and vertical position using the Position/Clock screen. See page E-40 for more
details.
DVI IN AUDIO IN
AUDIO IN
RGB IN
AUDIO OUT
RGB OUT
L/MONO R
PC CONTROL VIDEO AUDIO IN
MOUSE
S-VIDEO AUDIO IN
OUTPUT
REMOTE
CONTROL
INPUT
AUDIO OUT
When Viewing a DVI Digital Signal:
To project a DVI digital signal, be sure to connect the PC and the pro-
jector using a DVI-D signal cable (not supplied) before turning on your
PC or projector. Failure to do so may not activate the digital output of
the graphics card resulting in no picture being displayed. Should this
happen, restart your PC.
Do not disconnect a DVI-D signal cable while the projector is running.
If the DVI-D signal cable has been disconnected and then re-connected,
an image may not be correctly displayed. Should this happen, restart
your PC.
E – 24
To DVI digital or
DVI analog
DVI cable (not supplied)