Change Uefi Settings - NEC N8190-7157A User Manual

Change UEFI settings

If the Boot Mode setting is "UEFI", follow the instructions below to change this product's UEFI
settings (registering Boot device and enabling Boot) after preparations.
1> Turn on the computer which this product is installed.
2> Set "Enabled" the Option Rom of PCI slot which installed this product connected to the Fibre
Channel device, then save changes and reboot the computer. Refer to the computer's User's Guide
for how to enable the Option Rom of PCI slot.
3> Select "UEFI Driver Configuration" submenu in the SETUP utility of the computer. Refer to the
computer's User's Guide for how to use the SETUP utility.
4> Select this product (LPe16000B) from the list of devices which UEFI driver loaded. Then, you see the
settings menu like:
5> Select "Set Emulex Adapter to Default Settings" and press <Enter> to set this product's configuration
to defaults. Select "Set Adapter Defaults" and press <Enter> when this menu is displayed.
Then press <Esc> to return to main menu.
Do not select "Back to UEFI Device Manager and RECONNECT DEVICES". Press
<Esc>, when you want to return to the adapter list.
The menu sample is just for your reference. Some of them may be different
depending on the computer or its configurations.