Confirm Wwpn Addresses At The Computer Boot (Uefi) - NEC N8190-7157A User Manual

Confirm WWPN addresses at the computer boot (UEFI)

If the Boot Mode setting is "UEFI", follow the instructions below to confirm WWPN addresses.
1> Confirm that this product is properly connected with the Fiber Channel device. Then, turn on the
computer.
2> Set "Enabled" the Option Rom of PCI slot which installed this product, then save changes and reboot
the computer. Refer to the computer's User's Guide for how to enable the Option Rom of PCI slot.
3> Select "UEFI Driver Configuration" submenu in the SETUP utility of the computer. Refer to the
computer's User's Guide for how to use the SETUP utility.
4> Select this product (LPe16000B) from the list of devices which UEFI driver loaded. Then, check the
Node Name Value, when this menu is displayed. By changing the Node Name header "2000" to
"1000", you will get WWPN address.
Example: Node Name "2000 0090 FA21 1128" -> WWPN address"1000 0090 FA21 1128"
5> Press <Esc> key to return to the list of devices, and confirm the WWPN address of the other port of
this product by the same step from 4>.
6> If you have confirmed all WWPN address of this product, restore Option ROM settings which had
changed in step 2>. Then save changes and exit the SETUP utility of the computer.
Do not select "Back to UEFI Device Manager and RECONNECT DEVICES". Press
<Esc>, when you want to return to the adapter list.
The menu sample is just for your reference. Some of them may be different
depending on the computer or its configurations.
Press <Esc> to return to the adapter list. If select "Back to UEFI Device Manager
and RECONNECT DEVICES" and press <Enter>, press <Alt>, <Ctrl> and <Del>
keys simultaneously to reboot the computer.
beginning.
Then, start the steps from the