Determining The Installation Position - Huawei SUN2000-250KTL Series User Manual

SUN2000-(250KTL, 280KTL, 300KTL, 330KTL) Series
User Manual
Table 4-6 Auxiliary materials and other tools
Label
Heat-shrink
tubing

4.3 Determining the Installation Position

Installation Environment Requirements
●
●
●
●
●
●
●
●
●
●
●
Issue 02 (2022-12-20)
Cable tie
Insulation tape
Do not install the inverter in working or living areas.
If the device is installed in public places (such as parking lots, stations, and
factories) other than working and living areas, install a protective net outside
the device, set up a safety warning sign to isolate the device, and prevent
unauthorized personnel from approaching the inverter. This is to avoid
personal injury or property loss caused by accidental contact or other reasons
during device operation.
If inverters are installed in a place with abundant vegetation, in addition to
routine weeding, harden the ground underneath the inverters using cement or
gravel (recommended area: 3 m x 2.5 m).
Do not install the inverter in areas with flammable materials.
Do not install the inverter in areas with explosive materials.
Do not install the inverter in areas with corrosive materials.
Do not install the inverter where its enclosure and heat sinks are easily
accessible, because the voltage is high and these parts are hot during
operation.
Install the inverter in a well-ventilated environment for heat dissipation
If the inverter is installed in an airtight environment, a heat dissipation device
or ventilation device must be installed to ensure that the indoor ambient
temperature is not higher than the external ambient temperature during
operation.
You are advised to install the inverter in a sheltered place or install an awning
over it.
The inverter will be corroded in salt areas. Before installing the inverter
outdoors in salt areas, consult Huawei. A salt area refers to the region within
Copyright © Huawei Technologies Co., Ltd.
Cotton cloth
Brush
4 Installation
Sandpaper
Vacuum cleaner
28