Selects whether the information OSD is displayed or not. The information OSD will be
displayed when the input signal or source changes. The information OSD will also give a
warning when there is no-signal or the signal is out-of range.
An interval between 3 to 10 seconds for the Information OSD to appear is available.
MONITOR INFORMATION Monitor Information.
CARBON SAVINGS: Display the estimated carbon saving information in kg. The carbon
footprint factor in the carbon saving calculation is based on the OECD (2008 Edition).
Set the transparency level of the OSD.
Determines the OSD display direction between landscape and portrait.
Display the OSD with landscape mode.
Display the OSD with portrait mode.
You can create a name for the INPUT currently being used.
Max: 8 characters, including Space, A-Z, 0-9, and some symbols.
Activates closed captioning.
VIDEO1, VIDEO2, S-VIDEO inputs only
Resets the following settings within the OSD menu back to factory setting:
OSD TURN OFF, OSD POSITION, INFORMATION OSD, OSD TRANSPARENCY,
Sets the monitor ID number from 1-100 and group ID from A-J.
NOTE: Group ID is made of multiple selections.
Selects the mode of the monitor for use with the infra-red remote control when using the
RS-232C daisy chain.
The monitor will be controlled normally using the remote controller.
Choose "PRIMARY" for the first monitor within an RS-232C daisy chain.
Choose "SECONDARY" for all subsequent monitors within an RS-232C daisy chain.
Prevents the monitor from being controlled by the wireless remote controller. To return to
normal operation, press the "DISPLAY" button on the remote controller for 5 seconds.
Allows one image to be expanded and displayed over multiple screens (up to 100) through a
NOTE: Low resolution is not suitable for tiling to a large number of monitors. You can operate
without a distribution amplifier at a lower number of screens.
Number of monitors arranged horizontally.
Number of monitors arranged vertically.
Select which section of the tiled image to be displayed on the monitor.
Turns the TILE COMP feature on.
Enables Tile Matrix.
POWER ON DELAY
Adjusts the delay time between being in "standby" mode and entering "power on" mode.
"POWER ON DELAY" can be set between 0 and 50 seconds.
Turns ON or OFF the LED located at the front of the monitor.
If "OFF" is selected, LED will not light when the LCD monitor is in active mode.
Selects the control interface, RS-232C or LAN.
Resets the LAN settings.
When controlling the monitor externally, select if the communication command, which specifies
destination equipment ID (ALL or GROUP ID), is replying or not. Use this function as necessary,
if you connect the multiple monitors that are daisy-chained from secondly monitor by RS-232C.
Displays the MAC ADDRESS.
ON, 3 Sec.