Product Properties - APRILIA V990 Manual

V990 engine
 #/.35-!",%3
Only use the products given below for any mainte-
nance work.
The materials mentioned have been tested for many
years and are suitable for all the application condi-
tions indicated by the manufacturer.
NOTE
The consumables, which are coded, are availa-
ble on application, see 2.4.2 (USE OF CONSUMABLES).

2.4.1 PRODUCT PROPERTIES

APRILIA part# (product)
aprilia part# 0897651 [LOCTITE
243 blue (10 cm³)]
aprilia part# 0898011 (fluorescent
®
green LOCTITE 275) (**)
aprilia part# 0899788 [LOCTITE
648 green (5 g)]
aprilia part# 0899784 (LOCTITE
574 orange)
aprilia part# 8116067 (LOCTITE
8150)
aprilia part# 0297434 (LOCTITE
767 Anti-Seize 15378)
aprilia part# 0297433 [MOLYKOTE
G-N (50 g)]
aprilia part# 0297386 [SILASTIC
732 RTV (100 g)]
Release 00/2001-06
®
Adhesive in paste for screws and nuts up to M36 and for
couplings with medium hold.
It can be used on parts which have not been completely
degreased.
The hardening time depends on the temperature and the
material (maximum one hour).
Resistance to temperatures in the range – 55 to 150 °C (– 99 to
302 °F).
It prevents the loosening of the threaded components and the
fluid leakages due to vibrations.
It must be used on clean, degreased and non-oxidized
components.
Apply a quantity sufficient to cover all the threaded part.
Paste for strong fastening of screws.
®
The hardening time depends on the temperature and the
material (maximum twelve hours).
Resistance to temperatures in the range -55 to 175 °C ( – 99 to
347 °F).
In order to release the part glued, it may be necessary to heat
the coupled parts to a temperature of 250 °C (482 °F).
® Solvent-free seal in paste, to be used instead of seals where
there is a high friction factor and where a precise distance is
required between the two components.
Applied in its liquid state, it hardens after assembly on contact
with the metal within a few hours.
A seal is created whose surface structure adapts to the surfaces
to be sealed.
Resistance to temperatures in the range – 55 to 200 °C (– 99 to
392 °F); where applied, it seals the surfaces against corrosion.
®
Paste to be used on components subjected to high temperature.
®
Lubricant and anticorodal resistant to high temperatures.
It must be sprayed on both components and makes sure the
sliding surfaces remain maintenance free for a long time.
It prevents corrosion.
®
Lubricating paste to be used on support points subjected to
heavy loads, for standard lubrication and on couplings under
pressure, in order to prevent corrosion which would prevent
subsequent disassembly.
To apply on the two surfaces.
It is used as a sealant, preventing water from getting inside the
flywheel cover.
TECHNICAL INFORMATION
Use and properties
2 - 11
- 00