Sprout Nomad Trek+ Instruction Manual page 11

04.
Operating Controls
Connecting Multiple Devices via UNISYNC
®
Using the UNISYNC feature you can connect up to
®
50 UNISYNC -compatible devices. In this example,
®
your Nomad Trek+ is your primary device.
To connect a replica, short press the UNISYNC
®
button on your primary device once to enter
UNISYNC Mode. Once the primary announces
®
it is in UNISYNC Mode, repeat on the replica.
®
After the replica announces it is in UNISYNC
®
Mode, press the UNISYNC button – the replica will
®
announce it is using UNISYNC Audio. The primary
®
speaker will show a solid blue light while replicas will
show a flashing red and blue light.
Press UNISYNC button again to disable UNISYNC .*
® ®
Press and hold the UNISYNC button for five seconds
®
to reset the UNISYNC function.**
®
*If UNISYNC is disabled, Nomad Trek+ will
®
disconnect from but remember the replicas
connected to it.
**Resetting UNISYNC will enable Nomad Trek+
®
to 'forget' all replica devices.
11