Structural Concepts Harmony HMG2642R.4439 User Manual page 9

INSTALLATION: PROGRAMMABLE CONTROLLER
14. Programmable Controller (All Self- Contained Units and some Remote Units)
• Check that compressor symbol light is on.
• SCC-Supplied temperature controller compressor is identified with:
• After case has run for a few minutes, check that temperature starts to drop.
• If temperature controller does not begin cooling (in a few minutes) see temperature controller section in
this operating manual for instructions.
• Remote units (without temperature controller on case): Verify that refrigeration requirements listed on
serial label (found on the case) are being met.
• See Programmable Controller section in User Manual for additional information.
15. Saturated Suction Temperature (Remote Units)
• See serial label on case for suction temperature requirements and BTU requirements.
• See serial label on case for defrost schedule and temperature termination parameters.
9