Yamaha TRACER 9 GT Owner's Manual page 44

Instrument and control functions
"Shift Indicator"
Shift Indicator
IND Mode
IND Start
IND Stop 10000 r/min
5
This module allows a custom shift indi-
cator to be set. When the engine r/min
(rotations per minute) are in the speci-
fied range, the gear indicator will flash.
This module has 3 options:
"IND Mode" - the shift indicator can be
turned ON/OFF
"IND Start" - the r/min at which the in-
dicator starts flashing can be chosen.
Once selected, rotate the wheel switch
up/down to increase or decrease the
r/min value by increments of 200 r/min.
"IND Start" is settable between 6000 -
12800 r/min.
"IND Stop" - the r/min at which the in-
dicator stops flashing can be chosen.
Once selected, rotate the wheel switch
up/down to increase or decrease the
r/min value by increments of 200 r/min.
"IND Stop" is settable between 6200 -
13000 r/min.
"Maintenance"
ON
8000 r/min
km/h
This module allows you to record the
distance traveled between engine oil
changes (use the OIL item), and for two
other items of your choice (use INTER-
VAL 1 and INTERVAL 2).
To reset a maintenance trip meter, se-
lect it and then press and hold the
wheel switch.
TIP
Maintenance item names cannot be
changed.
Maintenance
OIL 1000
km
INTERVAL 1 1000
km
INTERVAL 2 1000
km
km/h
5-19
"Unit"
Unit
km or mile
km/L or L/100km
L/100km
°C or °F
This module allows you to switch the
display between metric and imperial
measurement units.
When using kilometers, the fuel con-
sumption units can be changed be-
tween "km/L" or "L/100km". When
using miles, MPG will be available.
Temperature units can be switched
between Celsius and Fahrenheit.
km
°C
km/h