Punch Controller Pcb; Removing The Upper Cover; Removing The Punch Controller Pcb - Canon Finisher-Q1 Service Manual

2) Remove the screw[1]and
connector[2].
3) Remove the scrap full detector PCB [3].
[2]
[1]
F-3-23

3.3.3 Punch Controller PCB

3.3.3.1 Removing the Upper
Cover
1) Remove the screw [1] at the front.
[1]
F-3-24
2) Remove the two screws [1] at the back to detach the
upper cover [2].
disconnect the
[3]
0008-1875
[2]
[1]
F-3-25
3.3.3.2 Removing the Punch
Controller PCB
1) Remove the screw [1] to move the plate [2] to the
left.
[1]
[2]
F-3-26
2) Flip up the Mylar [1] and disconnect the seven
connectors [2].
3) Remove the two screws [3] to remove the punch
controller PCB [4].
Chapter 3
0008-1815
3-7