Variable Resistors (Vr), Light-Emitting Diodes (Led), And Check Pins By Pcb; 1Light-Emitting Diodes And Check Pins By Pcb; 2Finisher Controller Pcb - Canon Finisher-U1 Portable Manual

Chapter 3

3.2 Variable Resistors (VR), Light-Emitting Diodes (LED), and Check Pins by PCB

3.2.1 Light-Emitting Diodes and Check Pins by PCB
Of the light-emitting diodes (LED) and check pins used in the machine, those needed in the field when servicing the machine are discussed herein.
Do not use the variable resistors (VR) and check pins that are not discussed herein. A check using these will require the use of special tools/instruments and a
high level of accuracy.
3.2.2 Finisher Controller PCB
SW1: Use it for mode setting
SW2: Use it for adjustment and test start-up
LED1:Use it for checking the operation
8
Connector
J1 power supply
J2 communication
PI1
J903 PI2
PI3
PI15
J904
PI16
PI7
PI8
J905
PI9
PI10
J906 M1
J907 M2
F-3-2
F-3-3
T-3-3
Target
-
-
stack edging HP sensor
handing tray paper sensor
paper surface sensor
inlet sensor
offset HP sensor
tray clock sensor
stack tray paper sensor
tray 300 sensor
tray lower limit sensor
stack tray shift motor
feed motor
0010-1711
0010-1712