Table of Contents
Advertisement
OPERATION
USING THE T 755 –SETUP MENU
16
SETUP MENU
The Setup Menu allows one to customize the operation of the T 755 to the ancillary equipment used
in one' s specific AV system. Unless your system exactly matches the factory defaults as shown in the
accompanying Quick Start Guide, you will need to use the setup menu to configure the inputs of the T 755.
At Setup Menu, the following are configurable – Source Setup, Speaker Setup, Zone Setup, Trigger
Setup, Listening Mode Setup, Display Setup and A/V Presets.
To access and navigate through Setup Menu and its sub-menu selections, please refer to and follow
the directions stated in the sections "DISPLAY THE OSD" and "NAVIGATING THE OSD AND MAKING
CHANGES".
SOURCE SETUP
From Source Setup menu, pressing [
adjust allocate or change the settings of the following – Source Setup (Normal View), Source Setup
(Table View) and iPod Setup.
SOURCE SETUP (NORMAL VIEW)
The Source Setup (Normal View) makes it possible to set, allocate or change the following settings.
SOURCE
The T 755 is equipped with ten configurable Sources. The settings for each Source are dependent on
the configurations set forth in the parameters for that particular Source window.
To change or toggle through the Sources, scroll to "Source", press the buttons [
[
] to move up or down the Source selections.
NOTE
Source 5 is defaulted to iPod. For Source 5 to be changed and allocated for other inputs, go to "iPod
Setup" menu under the "Source Setup" menu. At iPod Setup menu, set "Enabled" to "No" – you can
now assign Source 5 to other inputs or settings as desired.
ENABLED
One can enable/disable a Source via this option. This is particularly useful if only few Sources are used
and one directly selects the Source from the front panel, bypassing unused sources.
To enable or disable a particular Source, scroll to "Enabled" and press [
NAME
A new Name maybe assigned to a Source label. For example, if your DVD player is attached to "Source
1", it is possible to rename "Source 1" to "DVD Player".
In order to rename the Source label, scroll to "Name" and press [
Then, press [
] to pick through the alphanumeric selections.
Press [
] to move to the next character and at the same time save the changes done on the
current character. The name can be as long as twelve characters.
The new Name will be shown in the VFD as well as on the OSD.
] will direct you to the Source Setup menu wherein you could
] keys to select "Yes" or "No".
] to go the character.
] and then ENTER or
Hide quick links:
Advertisement
Table of Contents
