Unpacking And Setup; What's In The Box; Save The Packaging; Choosing A Location - NAD T 763 Owner's Manual

UNPACKING AND SETUP

CONNECTING AM ANTENNA

Insert into the groove
6 6 6 6 6
WHA WHA WHA WHA

WHAT'S IN THE BOX

T'S IN THE BOX T'S IN THE BOX T'S IN THE BOX T'S IN THE BOX
Packed with your T 753 receiver you will find:
• An AM loop antenna
• A FM ribbon-wire antenna with balun
• A removable AC cable (if you wish, any IEC-standard AC cable of suitable wattage may be substituted).
• The HTR 2 remote control with 4 (four) AAA batteries.
• The ZR 2 zone remote control with 3V CR2025 battery.
• This owner's manual.

Save the packaging

Please save the box and all of the packaging in which your T 753 arrived. Should you move or otherwise
need to transport your receiver, this is by far the safest container in which to do so. We've seen too many
otherwise perfect components damaged in transit for lack of a proper shipping carton, so please: Save that
box!
CHOOSING A LOCA CHOOSING A LOCA TION TION
CHOOSING A LOCA CHOOSING A LOCA

CHOOSING A LOCATION

TION TION
Choose a location that is well ventilated (with at least several inches to both sides and behind), and that will
provide a clear line of sight, within 25 feet/8 meters, between the receiver's front panel and your primary
listening/viewing position—this will ensure reliable infrared remote control communications. The T 753
generates a modest amount of heat, but nothing that should trouble adjacent components. It is perfectly
possible to stack the T 753 atop other components, but the reverse usually should be avoided. Nonetheless,
it is generally preferable that the T 753 stand alone. It is especially important that sufficient ventilation be
provided; if you are contemplating locating the T 753 within a cabinet or other furniture, consult your NAD
audio/video specialist for advice on providing adequate airflow.
ASSEMBLING THE AM LOOP ANTENNA ASSEMBLING THE AM LOOP ANTENNA
ASSEMBLING THE AM LOOP ANTENNA ASSEMBLING THE AM LOOP ANTENNA ASSEMBLING THE AM LOOP ANTENNA
1 Rotate the outer frame of the antenna.
2 Insert the bottom edge of the outer frame into the groove on the stand.
3 Extend the antenna cord.