Disassembly Instructions - Mitsubishi Electric MLZ-KY06NA - U1 Service Manual

10

DISASSEMBLY INSTRUCTIONS

<Detaching method of the terminal with locking mechanism>
The terminal which has the locking mechanism can be detached as shown below.
There are 2 types of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
MLZ-KY06NA
NOTE: Turn OFF the power supply before disassembly.
OPERATING PROCEDURE
1. Removing the intake grille
(1) Slide the tabs (2 places) of intake grille in the direction
of the arrow (Figure 1).
(2) Hold the intake grille and pull it down to open (Figure 2).
(3) Slide the grille shafts (1 each on the left and right
sides) off the intake grille and remove the intake grille
(Figure 3).
(4) Remove the safety strings of intake grille from the
hooks (Figure 4).
Figure 1
Tab
Figure 3
OBH922
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Intake grille
Press
Shaft
Slide
inward.
(2) The terminal with the connector shown below
locking mechanism.
Connector
: Indicates the visible parts in the photos/figures.
: Indicates the invisible parts in the photos/figures.
PHOTOS/FIGURES
Photo 1
Places for installing the air cleaning filter.
[Anti-allergy Enzyme Filter (option)]
Remote control
[Install to air filters.(Air purifying filter)]
receiving section
Electrical parts
Safety string
Places for installing
Figure 2
the air filter(Air purifying filter)
Figure 4
Safety string
35
Hold the sleeve, and
pull out the terminal
slowly.
Horizontal vane
Safety string
Intake grille
Hook