Gigaset SL800 H PRO Manual page 60

Setting the handset
During a call
A sound and a message on the display indicate when encryption is disabled on the base during
a call.
Continue call:
Stop call:
If neither is pressed, the call is stopped automatically after a certain time.
Testing the secure connection status during a call:
Press the Hash key
display
Handset update
The handset supports firmware updating via the DECT radio link to the base/router
(SUOTA = Software Update Over The Air).
The base/router to which the handset is registered must also support this function
( wiki.gigasetpro.com)
If your base/router does not support this function, you can also update the firmware
via a USB cable and Gigaset Quick Sync.
The phone checks whether new firmware is available for the handset. If it is, a message is
displayed.
Start the firmware update with Yes.
Enable/disable automatic check for new firmware:
Settings
Automatic Check
Start the firmware update manually
Settings
Update OK
The update process may take up to 30 minutes. During this time, only restricted
handset use is available.
Checking the firmware version
Settings
Current Version
60
Yes
No
for a longer time . . . the secure connection status is shown on the
OK System
OK Change (
OK System
OK . . . if there is new firmware, the update will start
OK System
OK . . . the firmware version of the handset is displayed
Availability and operation of the functions
may differ on your telephone.
OK Handset Update
= enabled)
OK Handset Update
OK Handset Update
OK
OK
OK